Riser is only for Creality K2 Pro with glass.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Riser is only for K2 Pro with glass.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 61
- Wydruki
- 2
- Wyświetlenia
- 636
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I looked up the design from the Bambu community. But since Riser did not find a similar design for the K2 PRO, he made the model himself. There is only support in two places where the dovetail connection is used. (Unfortunately, I did not find a solution to make the first cut at 90 degrees). I used a tolerance of 0.3 in the dovetail joint, as I planned to install it on glue. Additionally, I pasted thick paper at the points of contact with the glass, since glass does not like irregularities. I used the "Gyroid" filling by 15%. This is enough for durability and printing speed.
Tip: for high-quality surface printing, print as far away from the side fan as possible, so there will be no damage from the air jet. I also attached the layout file.
PS And yes, the cooling is good, until the temperature rise is detected with the door closed.
PSS I have a better version: