Moisture apsorber cases for fillament storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Moisture cases for storing filament and drying after wards For Creality Space PI dryer .
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 73
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Public Domain
Round PLA cases for silicon moisture absorber orange one , with elastic bands sawn betwine cases .
lower case should be made with 100% infill top covers can be made with 15% , 100 % is because when you try to put it on a spool you squeeze sides and there is some times a lot of force on bars , earlier design have broken with thinner bars .
M3 screw length of 50 mm screw is needed and two M3 nuts . use elastic band with width around 30 mm if you use wider it becomes a lot more difficult to place it around the spool.
There are also a 3 storage containers for drying silica when it becomes black , general time is around 6 hours , on ABS setting , the storage containers need to be from ABS because of temperature of 65 degrees. It was design to be used with Creality Space PI filament dryer . There is also a tool for pouring silica back in containers . Just place it over a drying containers and flip up side down .