1 / 1
Antilop Footrest - thicker tabs and wider leg holes
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified the original to fit my antilop highchair. Uses the joiner and collar from the original model.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 263
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
Modified the original to fit my antilop highchair. Uses the joiner and collar from the original model.
If printing in PETG I recommend you cut out and print the locking tabs first. If not dialed in and dried the tabs may be brittle and snap off. It's better to check the difficult bit before you waste 100g of filament and have the tabs fail at the very end.
Left: Before dialing in and drying my clear PETG, brittle and easy to break
Right: After dialing in, smooth and strong
