Beauty Dish M5 Screw and Washer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is replacement part for this screw found on a 36" Beauty Dish for photography. It has a longer screw and washer
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is replacement part for this the knurled screw found on a 36" Beauty Dish for photography. It has a longer screw, slightly taller knurle and thicker washer
Both the screw, the and the washer are lengthened to allow for easier grip and tighter hold without much twisting, but I was able to hand tighten it quite a bit and no signs of breaking thread or screw.
Here are my settings to get the M5 screw threads correct and make sure the screw is tough:
PRINTER: Flashforge AD5X 0.4mm nozzle
MATERIAL: JEYO PLA+
=== STRENGTH (Recommended Optimizations) ===
Wall Loops: 6 (increased from 2)
Detect Thin Walls: Enabled
Top Shell Layers: 5
Top Shell Thickness: 1 mm
Top Surface Density: 100%
Top Surface Pattern: Monotonic
Bottom Shell Layers: 5 (increased from 3)
Bottom Shell Thickness: 1 mm (changed from 0 mm)
Bottom Surface Density: 100%
Bottom Surface Pattern: Monotonic
Top/Bottom Solid Infill/Wall Overlap: 10% (reduced from 25%)
=== INFILL ===
Sparse Infill Density: 100%
Fill Multiline: 2
Sparse Infill Pattern: Honeycomb
Sparse Infill Direction: 45°
Internal Solid Infill Pattern: Rectilinear
Solid Infill Direction: 45°
Maximum Infill Anchor Length: 20 mm
Sparse Infill Anchor Length: 400%
Apply Gap Fill: Everywhere
Filter Out Tiny Gaps: 0.1 mm
Infill/Wall Overlap: 10%
=== PRINT SETTINGS ===
Layer Height: 0.15 mm
Nozzle Temperature: 210°C
Orientation: Vertical (screw axis along Z)