Beauty Dish M5 Screw and Washer
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is replacement part for this screw found on a 36" Beauty Dish for photography. It has a longer screw and washer
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 8
- Makes
- 0
- Views
- 44
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Ideas
- License
- Creative Commons — Attribution — Share Alike
This is replacement part for this the knurled screw found on a 36" Beauty Dish for photography. It has a longer screw, slightly taller knurle and thicker washer
Both the screw, the and the washer are lengthened to allow for easier grip and tighter hold without much twisting, but I was able to hand tighten it quite a bit and no signs of breaking thread or screw.
Here are my settings to get the M5 screw threads correct and make sure the screw is tough:
PRINTER: Flashforge AD5X 0.4mm nozzle
MATERIAL: JEYO PLA+
=== STRENGTH (Recommended Optimizations) ===
Wall Loops: 6 (increased from 2)
Detect Thin Walls: Enabled
Top Shell Layers: 5
Top Shell Thickness: 1 mm
Top Surface Density: 100%
Top Surface Pattern: Monotonic
Bottom Shell Layers: 5 (increased from 3)
Bottom Shell Thickness: 1 mm (changed from 0 mm)
Bottom Surface Density: 100%
Bottom Surface Pattern: Monotonic
Top/Bottom Solid Infill/Wall Overlap: 10% (reduced from 25%)
=== INFILL ===
Sparse Infill Density: 100%
Fill Multiline: 2
Sparse Infill Pattern: Honeycomb
Sparse Infill Direction: 45°
Internal Solid Infill Pattern: Rectilinear
Solid Infill Direction: 45°
Maximum Infill Anchor Length: 20 mm
Sparse Infill Anchor Length: 400%
Apply Gap Fill: Everywhere
Filter Out Tiny Gaps: 0.1 mm
Infill/Wall Overlap: 10%
=== PRINT SETTINGS ===
Layer Height: 0.15 mm
Nozzle Temperature: 210°C
Orientation: Vertical (screw axis along Z)