Mega Drill Bit Organizer XXL (287 holes)

⚠ WARNING: Read before printing!

• Drill Bit fitting: Please note that the hole diameters are designed for metric drill bits where the shank (base) is the same diameter as the cutting edge, which is typical for wood and metal bits. However, concrete bits (or any custom bits) often have a smaller / different shank and may not fit as intended in the correct section.

• Slicer Nightmare: Full disclosure: Slicing this model was an absolute pain in the neck due to my computer's low performance (8GB RAM). Be aware that you might experience the same depending on your computer's performance.

• Print Time: I needed an 18-hour print with prusa core one with 0.20 structural profile in prusa slicer.

• Tolerance Update: I have resized the 1mm holes from the original prototype shown in the photos. The initial version lacked enough play, so I’ve updated them to use the same clearance as the 1.5mm holes. I kept the version from the picture as it fits my needs. No problems with any of the other holes.

• Future Updates: I am currently working on a "Light" version. I’m experimenting with hexagonal holes to drastically reduce the polygon count and G-code size to try and optimize the slicing.

💡 Color Change Tip:

The color change needs to be done at 23.2mm if you print at 0.2mm layer height (layer 116). I added an M600 function manually in the G-code because it was impossible to do with the slicer without my computer freezing.