Kossel 2020 Corner Reinforcement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
IMPORTANT! DO NOT JUST PRINT 6 OF THESE. You'll need 3 Left and 3 Right braces -- so you'll need to MIRROR the design…
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 797
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
IMPORTANT! DO NOT JUST PRINT 6 OF THESE. You'll need 3 Left and 3 Right braces -- so you'll need to MIRROR the design to get the second 3!
Corner reinforcement for an Openbeam 2020 Kossel. I wasn't sure I needed these, but the lack of rotational bracing on Kossel corners always bugged me so I gave this a try -- and it definitely does make a difference, albeit not a huge one. The structure is more rigid and ringing artifacts are tighter/smaller. I haven't put them on the top of mine yet, just the bottom, but they should have adequate clearance (at least on my linear Kossel).
Designed for M4x8mm bolts -- you'll need 4 per brace or 24 total. Use a fairly dense supporting grid for best results.
You'll also want to re-level your printer after installing these. I've had no printing issues since putting mine on and re-leveling.
6/1/2018 NOTE: if you want to take your frame rigidity to the next level FO REALS, check out my complementary wire brace system here: https://www.thingiverse.com/thing:2941886
10/24/18 NOTE: And spreader arms for that: https://www.thingiverse.com/thing:3173546
Print Settings
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
40%
Category: 3D Printer Accessories