Toughbuilt ClipTech cup holder

This is a cup holder I made specially for using with Toughbuilt ClipTech accesories but you can just screw it in a wall or wherever you’d like. To use with ClipTech, I made holes same distance and diameter as in other creator model of receiver (female) connector: https://www.printables.com/model/1432318-toughbuilt-cliptech-receiver 

Why use with ClipTech? My dad is and electrician and he has a foldable table to make his work easier on site (he mostly just puts a case with his tools on it). The table has those ClipTech male connectors on it's sides and he often knocks down his cup while working on table. So yes, it's a very overengineered solution for his specific problem.

CUP HOLDER INFO
Inner diameter: 74mm
Outer diameter: 88mm
Inner wall height: 147mm
Screw holes diameter: 5mm
Model dimensions: 88x90x184mm

PRINTING INFO
0.2 layer height, 3 wall loops, 3 bottom and top layers, 20% gyroid infill, PET-G, supports are only needed for screw holes so use Normal(auto) with snug, printing speeds are propably dependent on your filament type, bed temp - 70*, nozzle temp - 250* 

DISCLAIMER
I'm pretty new with printing PET-G filament (really it's my 3rd model printed with it after those 2 connectors mentioned here) so take my setting with a grain of salt - if u know better, just use your own settings.

USE BRIM OR GLUE - in my case a bit of a model peeled off because I didn't use any of it, but I just kept printing and it turned out fine.

If u want to have the cup holder detachable but don't have any original clip tech accesories, u can also print male connector but i recommend to sand it a little at the top: https://www.printables.com/model/1563607-toughbuilt-cliptech-wall-mount-receiver

I also attach a 3mf file with my ready config (SUNLU Black PET-G, Kobra 2 Pro, AnycubicSlicerNext) - just pick if u want config or just geometry in slicer.