Toughbuilt ClipTech cup holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cup holder for Toughbuilt ClipTech system or screw in wall/table system.
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 44
- Makes
- 0
- Views
- 336
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution
This is a cup holder I made specially for using with Toughbuilt ClipTech accesories but you can just screw it in a wall or wherever you’d like. To use with ClipTech, I made holes same distance and diameter as in other creator model of receiver (female) connector: https://www.printables.com/model/1432318-toughbuilt-cliptech-receiver
Why use with ClipTech? My dad is and electrician and he has a foldable table to make his work easier on site (he mostly just puts a case with his tools on it). The table has those ClipTech male connectors on it's sides and he often knocks down his cup while working on table. So yes, it's a very overengineered solution for his specific problem.
CUP HOLDER INFO
Inner diameter: 74mm
Outer diameter: 88mm
Inner wall height: 147mm
Screw holes diameter: 5mm
Model dimensions: 88x90x184mm
PRINTING INFO
0.2 layer height, 3 wall loops, 3 bottom and top layers, 20% gyroid infill, PET-G, supports are only needed for screw holes so use Normal(auto) with snug, printing speeds are propably dependent on your filament type, bed temp - 70*, nozzle temp - 250*
DISCLAIMER
I'm pretty new with printing PET-G filament (really it's my 3rd model printed with it after those 2 connectors mentioned here) so take my setting with a grain of salt - if u know better, just use your own settings.
USE BRIM OR GLUE - in my case a bit of a model peeled off because I didn't use any of it, but I just kept printing and it turned out fine.
If u want to have the cup holder detachable but don't have any original clip tech accesories, u can also print male connector but i recommend to sand it a little at the top: https://www.printables.com/model/1563607-toughbuilt-cliptech-wall-mount-receiver
I also attach a 3mf file with my ready config (SUNLU Black PET-G, Kobra 2 Pro, AnycubicSlicerNext) - just pick if u want config or just geometry in slicer.