1 / 3
(UNTESTED) GT1.5 clamps and belt tensioner for Rat Rig V-Core 3.1 w/ Toolhead 1.0 — zdjęcie 1
1 / 3

(UNTESTED) GT1.5 clamps and belt tensioner for Rat Rig V-Core 3.1 w/ Toolhead 1.0

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I haven't ordered any GT1.5 belts and pulleys, but I'm interested to try them out sometime.

Ocena
0 / 5
Polubienia
2
Pobrania
15
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

UNTESTED - I haven't bought the belt/pulleys yet. Also, do not print with a nozzle >0.4mm in diameter: The teeth look weak enough as is, so using a bigger nozzle would inhibit getting 2 perimeters per tooth.

I've been watching the GT1.5 craze that's going about, so I wondered what I would have to do to put it on my RR V-Core 3.1 w/ Toolhead 1.0. Besides the pulleys, these are the only pieces of the printer that are supposed to touch the teeth of the belt, so I tweaked these to theoretically work. I fear the overall belt gap on the tensioner is too tight, and I'm not sure how strong the front clamp teeth would be either. These would require really dialed in ABS or ASA shink offsets, as the total belt thickness of the GT1.5 is 1mm. Front clamp is also adjusted to be ~0.4 thicker to account for the thinner belt (and not requiring more parts to be reprinted) without adjusting the geometry of where the lip tucks into the screw or where the countersunk screw would tighten against the body's side.

Tagi