(UNTESTED) GT1.5 clamps and belt tensioner for Rat Rig V-Core 3.1 w/ Toolhead 1.0
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I haven't ordered any GT1.5 belts and pulleys, but I'm interested to try them out sometime.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 15
- Makes
- 0
- Views
- 112
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
UNTESTED - I haven't bought the belt/pulleys yet. Also, do not print with a nozzle >0.4mm in diameter: The teeth look weak enough as is, so using a bigger nozzle would inhibit getting 2 perimeters per tooth.
I've been watching the GT1.5 craze that's going about, so I wondered what I would have to do to put it on my RR V-Core 3.1 w/ Toolhead 1.0. Besides the pulleys, these are the only pieces of the printer that are supposed to touch the teeth of the belt, so I tweaked these to theoretically work. I fear the overall belt gap on the tensioner is too tight, and I'm not sure how strong the front clamp teeth would be either. These would require really dialed in ABS or ASA shink offsets, as the total belt thickness of the GT1.5 is 1mm. Front clamp is also adjusted to be ~0.4 thicker to account for the thinner belt (and not requiring more parts to be reprinted) without adjusting the geometry of where the lip tucks into the screw or where the countersunk screw would tighten against the body's side.