Simple Webcam Lens Cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a simple lens cover for a generic webcam that attaches by gripping the focus ring around the lens.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 52
- Wydruki
- 1
- Wyświetlenia
- 219
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple lens cover for a generic webcam that attaches by gripping the focus ring around the lens.
There are three versions:
Original: Designed to use a piece of scrap filament as the hinge pin
Thinner: Same as the original, but with a thinner cover
Snap Together: Same as the Thinner version, but does not need a hinge pin.
Print Settings
Printer Brand:
Creality
Printer:
CR-6 SE
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: Inland PLA + Neon Green
Notes:
You can slightly resize the split ring by placing the fingers in boiling water for a few seconds, then either tightening or widening the gap.
Don't leave it in the boiling water for more than a few seconds!
Category: Camera