corsair crystal 680x foot booster
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
booster to raise the height of my corsair 680x case this adds 50mm of height
- Ocena
- 3 / 5
- Polubienia
- 12
- Pobrania
- 55
- Wydruki
- 1
- Wyświetlenia
- 802
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
this was printed in Prusament silver PLA using a 0.6mm nozzle 2 walls/2top and bottom, 0.4 will also work fine but I would recommend 3 walls/top/bottom
needed a booster to raise the height of my corsair case to fit a blueray drive underneath.
this adds 50mm of height to the case
original foot screws into the bottom of the booster (this also taps the hole)
the booster is screwed into the the case from the INSIDE, note that the rear right corner is incredibly awkward for this as the hole has case metal formed over it inside, to counter this ( somewhat, it was still VERY difficult) I used a thumbscrew on this one to give me something to grip and then used needle nose pliers to turn it gradually to tighten once in place.