1 / 2
corsair crystal 680x foot booster — image 1
1 / 2

corsair crystal 680x foot booster

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

booster to raise the height of my corsair 680x case this adds 50mm of height

Rating
3 / 5
Likes
12
Downloads
55
Makes
1
Views
802
Reviews
1

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

this was printed in Prusament silver PLA using a 0.6mm nozzle 2 walls/2top and bottom, 0.4 will also work fine but I would recommend 3 walls/top/bottom 

needed a booster to raise the height of my corsair case to fit a blueray drive underneath. 
this adds 50mm of height to the case 

original foot screws into the bottom of the  booster (this also taps the hole) 
the booster is screwed into the the case from the INSIDE, note that the rear right corner is incredibly awkward for this as the hole has case metal formed over it inside, to counter this ( somewhat, it was still VERY difficult) I used a thumbscrew on this one to give me something to grip and then used needle nose pliers to turn it gradually to tighten once in place.  

Tags