Skoda Octavia 3 - Cup Holder Organiser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A cup holder organiser using only a single cup slot, with slots for a larger phone and the key fob, and coin slots.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 594
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
The OEM cup holder organiser from Skoda had 2 faults - the phone slot was too tight for my phone (S23 Ultra with a cover on), and it blocked part of the remaining cup holder, essentially rendering both centre cup holders unusable.
I tried to look for ready made models online, I found one that had a diagonal phone slot only, and this one with a dual phone slot set up. Seeing how they are designed to not block the second cup holder, they got my attention, despite some lacking features which I like in the original one - especially the key fob slot.
So I took the double phone holder model, and remixed it into this one by:
removing one phone slot, and enlarging the other one
adding a key fob slot instead of the double slot
adding a few coin slots
I made several variants to this model - they are split into 2.
Cup Holder Organiser - this has a closed off bottom, so it is recommended to print using supports.
Cup Holder Organiser (bottomless) - the bottom of the phone and key fob slots is left open, so it can be printed without supports, saves time, filament and adds a bit more depth into the organiser.
Each variant comes in different designs - with no logo, with the original Skoda logo of the era (2017), with the modern Skoda logo (2022 onwards), with the Laurin & Klement logo and with the vRS logo.
Recommended print:
without logo - top face of the organiser touching the build plate so that it gets the smoothest surface.
with logo - bottom face of the organiser touching the build plate so that the logo prints face up, does not look messy with overhangs.
use your preferred printer settings - it should be an easy print, make sure bed is levelled well and you have good bed adhesion to avoid warping of the initial layers, otherwise no raft or brim required.
depends on your climate, PLA should be just fine, but if you are in a very hot climate, try to use something more resistant to temperature
UPDATE - Modified Coin slots - they were too deep.