Petsfang Right CR Touch Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My first remix of the right probe mount for the petsfang base Mount did not fit the CR Touch well so I made some…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 43
- Wydruki
- 0
- Wyświetlenia
- 467
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
My first remix of the right probe mount for the petsfang base
Mount did not fit the CR Touch well so I made some modifications to allow clearance of the ribbon cable, and removed the middle hole as it was useless
1/2/22: Realized that the probe still did not clear completely. Will edit to fit better. Will also make the probe sit lower down so nozzle isn't so close to the bed
1/4/22: Uploaded a stretched version. Made the mount holes slightly smaller so you might be able to get away with reusing the stock screws
1/8/22: I edited the left side mount for better UBL purposes. It fits tighter than I would like (and pushes against the duct very hard) but once installed is very solid. I will probably be editing this a bit later on
Category: 3D Printer Accessories