Petsfang Right CR Touch Mount
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My first remix of the right probe mount for the petsfang base Mount did not fit the CR Touch well so I made some…
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 43
- Makes
- 0
- Views
- 467
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- Creative Commons — Attribution
My first remix of the right probe mount for the petsfang base
Mount did not fit the CR Touch well so I made some modifications to allow clearance of the ribbon cable, and removed the middle hole as it was useless
1/2/22: Realized that the probe still did not clear completely. Will edit to fit better. Will also make the probe sit lower down so nozzle isn't so close to the bed
1/4/22: Uploaded a stretched version. Made the mount holes slightly smaller so you might be able to get away with reusing the stock screws
1/8/22: I edited the left side mount for better UBL purposes. It fits tighter than I would like (and pushes against the duct very hard) but once installed is very solid. I will probably be editing this a bit later on
Category: 3D Printer Accessories