Dynafit adjustment plates classic
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Winter Sports
- Licencja
- Creative Commons — Public Domain
DIY toe shim and adjustment plate for dynafit comfort 5 screw toes. I had them laser cut by send cut send using 6061 Aluminium. I used material 4.75 mm thick to get the ramp angle between the toes and heels to the amount I wanted but you could use different thicknesses.
The file included is optimized for reducing print cost with the top and bottom piece connected. I used a hacksaw to split them and printed two copies.
Hardware from bolt depot below worked quite well.
5126 | Metric machine screws, Phillips flat head, Stainless steel 18-8 (A-2), 5mm x 0.8mm x 20mm | 12 pcs | $0.19 | $2.28 |
12 pcs | $0.06 | $0.72 | ||
4775 | Metric hex nuts, Stainless steel 18-8 (A-2), 5mm x 0.8mm |
If you are using a thinner Aluminium then you will have to use the jam nuts and shorter machine screws
13571 | Metric hex jam nuts, Stainless steel 18-8 (A-2), 5mm x 0.8mm |
Sourcing screws that go through the plate into the wood is a little tricky as you want 8-9mm of penetration into the ski. The holes in the plates are 5.8mm and really should have been 6mm for a better fit. I was able to use the original dynafit screws after drilling in a countersunk hole 1.5 mm into the top plate to get close to 8mm penetration into the ski.