Flashforge AD5X Enclosure Logo Inserts (1mm Low-Profile)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Logo inserts for the recessed "AD5X" lettering on the printer enclosure.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 345
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to give my enclosure a clean look, so I made these up to fit into the recessed AD5X logo on the printer's enclosure. These fit nicely, and only stick out a little as they are only 1mm thick.
Just print, apply a tiny amount of adhesive (superglue or double-sided tape if you can cut a piece small enough), and press them into place. I used superglue, placed something heavy on top for 5 mins, so I knew they would stick flat, and they came out even and looking good.
I printed these in PLA with standard Orca settings.