Seeed SenseCAP Indicator D1 enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure for the Seeed SenseCAP Indicator D1. Should work on all models, but was specifically made for the D1L.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 33
- Wydruki
- 0
- Wyświetlenia
- 262
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I designed this enclosure for a project that uses the Seeed SenseCAP Indicator D1L (the "Meshtastic" version with external antenna), specifically to hide some external electronics connected to the Grove connectors at the back.
This model only has cutouts for the external antenna and the button on top, plus a cutout for a USB-C cable at the back, but not for any of the inputs on the bottom (SD card, internal button, USB-C) or the vent/buzzer holes on the side (if you rely on the buzzer you may want to add/drill some holes to allow the sound to pass).
The enclosure relies on a friction fit to hold the Indicator so you can relatively easily slide it in/out of the enclosure.
I've printed this model in 3DJake PCTG and Eryone PLA+ with no special configuration. To make the walls a bit more sturdy (not necessary in my experience) you can increase the number of wall loops so the walls become solid. I've printed them with 15% gyroid infill, which came out fine. Printing in PLA+ takes about 90 minutes on my Bambu Lab P1S.
Supports aren't necessary. Best print orientation is with the backside flat on the print plate.