TruDesign T Handle Small 25mm/19mm/13mm (1", 3/4", 1/2")
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replacement handle or lever for TruDesign ball valve that is smaller than the original for tight spaces.
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 9
- Wydruki
- 1
- Wyświetlenia
- 33
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
A smaller handle/lever for your 25mm (1"), 19mm (3/4") or 13mm (1/2") TruDesign ball valve. Makes it easier to fit the ball valves in tight spaces where the original handle will not fit. Note that the original screw and screw cap are used.
I would have purchased the smaller handle/lever from TruDesign however Gemlux does not carry it in the USA.
I recommend considering the strength of the material when printing this. I chose to go with ASA as that seemed like the most appropriate strength of the filaments I had on hand. Unfortunately, I only had black ASA filament -- a different color would have been nice to make the handle stand out more.
Prints without supports (print with the socket that goes onto the ball valve pointing up).
