1 / 2
Endplate Cover - Corsair Frame 4000D Side Airflow Shroud — zdjęcie 1
1 / 2

Endplate Cover - Corsair Frame 4000D Side Airflow Shroud

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

An endplate for the Corsair Frame 4000D Side Airflow Shroud that hides PSU wiring and fan edge for a finished look

Ocena
0 / 5
Polubienia
0
Pobrania
17
Wydruki
0
Wyświetlenia
524
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

Corsair 4000D Shroud Aesthetic Endplate

This is an aesthetic add-on for the Side Airflow Shroud - Frame 4000D. While the original shroud is great for performance, it leaves a "nest" of PSU power cables and the raw edge of your fan frame visible from the side.

Update Log

  • [2026-02-04] - Added Fan-Compatible Version (v2 - Untested): Added a variant designed with adjusted clearance to fit a standard 120mm x 25mm thick fan. Please see the "Version Selection" section below.

Features

  • Cable Management: This endplate acts as a "beauty panel" to hide messy wiring and seal the side of the shroud for a professional look.

  • Perfect Alignment: Designed using the original file as a geometric reference to ensure the mounting holes and outer profile align perfectly with the shroud.

  • Flush Finish: Designed specifically for M4 Countersunk screws so the hardware sits flush with the plate surface.


Version Selection

I have provided two versions of this file:

  1. Endplate_NoSideFan (Verified): The version seen in the provided photos. It is designed for builds where the front-side fan is omitted (often due to HDD clearance issues).

  2. Endplate_WithSideFan (Untested): A revised version meant to work with a standard 120mm x 25mm thick fan.

    • Note: This version is currently untested. While it follows the original shroud's geometry, I have not yet verified the physical clearance with a fan installed.


Installation & Hardware

  • Hardware: Use M4 Countersunk screws to secure the plate to the existing shroud holes.

  • Setup: If you are not running a side fan, I recommend installing this alongside my 120mm Fan Blank for a completely sealed look.

Print Settings

  • Material: PETG or ASA (recommended due to proximity to PSU/GPU heat).

  • Layer Height: 0.2mm.

  • Walls/Perimeters: 3 for extra strength around the countersunk holes.

  • Supports: None required.

Tagi