1 / 2
Endplate Cover - Corsair Frame 4000D Side Airflow Shroud — image 1
1 / 2

Endplate Cover - Corsair Frame 4000D Side Airflow Shroud

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

An endplate for the Corsair Frame 4000D Side Airflow Shroud that hides PSU wiring and fan edge for a finished look

Rating
0 / 5
Likes
0
Downloads
17
Makes
0
Views
519
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution

Corsair 4000D Shroud Aesthetic Endplate

This is an aesthetic add-on for the Side Airflow Shroud - Frame 4000D. While the original shroud is great for performance, it leaves a "nest" of PSU power cables and the raw edge of your fan frame visible from the side.

Update Log

  • [2026-02-04] - Added Fan-Compatible Version (v2 - Untested): Added a variant designed with adjusted clearance to fit a standard 120mm x 25mm thick fan. Please see the "Version Selection" section below.

Features

  • Cable Management: This endplate acts as a "beauty panel" to hide messy wiring and seal the side of the shroud for a professional look.

  • Perfect Alignment: Designed using the original file as a geometric reference to ensure the mounting holes and outer profile align perfectly with the shroud.

  • Flush Finish: Designed specifically for M4 Countersunk screws so the hardware sits flush with the plate surface.


Version Selection

I have provided two versions of this file:

  1. Endplate_NoSideFan (Verified): The version seen in the provided photos. It is designed for builds where the front-side fan is omitted (often due to HDD clearance issues).

  2. Endplate_WithSideFan (Untested): A revised version meant to work with a standard 120mm x 25mm thick fan.

    • Note: This version is currently untested. While it follows the original shroud's geometry, I have not yet verified the physical clearance with a fan installed.


Installation & Hardware

  • Hardware: Use M4 Countersunk screws to secure the plate to the existing shroud holes.

  • Setup: If you are not running a side fan, I recommend installing this alongside my 120mm Fan Blank for a completely sealed look.

Print Settings

  • Material: PETG or ASA (recommended due to proximity to PSU/GPU heat).

  • Layer Height: 0.2mm.

  • Walls/Perimeters: 3 for extra strength around the countersunk holes.

  • Supports: None required.

Tags