Zooz ZSE70 Wrench
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wrench to easily remove the back of a Zooz ZSE70 motion detector.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 38
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
While the Zooz ZSE70 is a very nice Z-Wave LR outdoor motion detector, one issue I have with it is the thin back can be difficult to unscrew to change batteries or access the “Z-Wave button”. I designed this simple wrench to take care of that problem.
It’s designed to be a snug fit so you may want to do a test print, stopping the print after a couple of layers to see if the scaling is correct. Using my XL and PrusaSlicer I got a good fit with the scaling set to 100.20 for all three axes. While there is a chamfer on the bottom, be sure to remove any remaining elephant’s foot on the inside that may keep the wrench from slipping on easily. Note there is a small notch near the handle to give the aligned seams somewhere to go to avoid interfering with the slip fit.
Both STL and 3mf files are provided in case you want to tweak the design.
PLA+, Perimeters – 6, Seam Position – Aligned, Fill – Grid @ 50%, Scaling - Consider starting with 100.20 - 100.30.