1 / 5
F1-style Rear Wing for RC Car — zdjęcie 1
1 / 5

F1-style Rear Wing for RC Car

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

F1-style rear wing for RC-cars; specifically FTX Tracer.

Ocena
0 / 5
Polubienia
4
Pobrania
60
Wydruki
0
Wyświetlenia
323
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Wider than original rear wing spoiler designed for the FTX Tracer; with hole distance 30,5mm and 2.5mm scews. Original screws were used. The wing allows for (almost) maximum supsension travel. There was no wind tunnel testing; aero advantages rely mainly on placebo effect.

  • Printed in PLA, 0.4mm nozzle, 0.15mm layer height

  • Prints flat on the back without supports, but for my latest print I did use supports in the holes.

  • May be printed without infill, but using a modifier to add 20% infill around the holes is recommended.

Tagi