1 / 5
F1-style Rear Wing for RC Car — image 1
1 / 5

F1-style Rear Wing for RC Car

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Estimated printing price per file

€0.79 – €0.96 net (excluding VAT)

For file: TRACER F1 REAR WING_0.4n_0.15mm_PLA_COREONE_47m.bgcode

This is an estimate for one file. You’ll confirm the exact price before ordering.

File and estimate settings

File used for this estimate

Average indicative estimate: €0.88 excluding VAT (range midpoint).

Weight reported by the author
13 g
Print time reported by the author
46.8 min
Source material
PLA
Estimate material
PLA
Estimate printer
Bambu Lab P1S - 0.4 nozzle
Estimate process
0.20mm Standard

Indicative estimate for the selected file only, based on the author’s weight and print time. File variants are not added together. The final price is calculated after file analysis.

Saved on this device.

F1-style rear wing for RC-cars; specifically FTX Tracer.

Rating
0 / 5
Likes
4
Downloads
60
Makes
0
Views
323
Reviews
0

Updated at source:

Model information

License
Creative Commons — Attribution — Noncommercial — Share Alike

Wider than original rear wing spoiler designed for the FTX Tracer; with hole distance 30,5mm and 2.5mm scews. Original screws were used. The wing allows for (almost) maximum supsension travel. There was no wind tunnel testing; aero advantages rely mainly on placebo effect.

  • Printed in PLA, 0.4mm nozzle, 0.15mm layer height

  • Prints flat on the back without supports, but for my latest print I did use supports in the holes.

  • May be printed without infill, but using a modifier to add 20% infill around the holes is recommended.

Tags