1 / 3
AD5X Poop Chute Small Bin holder + bin with ramp — zdjęcie 1
1 / 3

AD5X Poop Chute Small Bin holder + bin with ramp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Small bin holder for Mark Litchfield's AD5X poop chute + ramped bin

Ocena
0 / 5
Polubienia
3
Pobrania
40
Wydruki
0
Wyświetlenia
491
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I used Mark Litchfield's poop chute design and designed a holder for the small bin so that it will always sit in the same exact position after every dump. It uses the screws that are already by the side of the frame. No support needed

I have uploaded 2 versions:
Version A extends the tray below the feet of the print. great if your printer's side is hanging off an edge.

Version B sits right at the same level as the feet but acts as a place you will always drop the tray in the right place. (It floats roughly 0.5mm above the floor)

 UPDATE 04/03/26: I added my own version of the small bin, with a ramp that helps lead the filament down to the end. Yes, less volume, but it helps move the poop down to the end.  There are 2 versions: 1 as a chamfered ramp and 1 as a filet'd ramp. pick whichever you like.

Here is the link to the original design that I made this tray for specifically.

https://www.printables.com/model/1512904-ad5x-poop-chute

Tagi