1 / 1
Stamp Hueforge Hanging Gardens of Babylon — zdjęcie 1

Stamp Hueforge Hanging Gardens of Babylon

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A stamp-like hueforge.

Ocena
0 / 5
Polubienia
8
Pobrania
5
Wydruki
0
Wyświetlenia
41
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Hello,

this is the third part of the seven wonders, i used Ferdinand Knab's paintings as source model. You can resize the image in your slicer to 200*160 mm before slicing (i did it so, to make all print at the same size); and you can use any other black filament type, about the others i am not sure, but feel free to experiment. There is two .stl file, one with the stamp-like effect, and one without.

Printing:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 202.54x160.2mm in size

You may print at higher layer heights below the Base Thickness of 0.48mm

The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm

#000000 PLA BambuLab Matte Charcoal Transmission Distance: 0.6

#ff9016 PLA BambuLab Basic Pumpkin Orange Transmission Distance: 5.5

#fec600 PLA BambuLab Basic Sunflower Yellow Transmission Distance: 4.4

#ffffff PLA BambuLab Basic Jade White Transmission Distance: 5

This print uses 4 unique filaments

Swap Instructions:

Start with Charcoal

At layer #10 (0.88mm) swap to Pumpkin Orange

At layer #16 (1.36mm) swap to Sunflower Yellow

At layer #21 (1.76mm) swap to Jade White for the rest.

Hope you like it, leave a comment, and have a nice day

Tagi