Stamp Hueforge Mausoleum at Halicarnassus
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A stamp-like hueforge.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 45
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- 2D Plates & Logos
- Licencja
- Creative Commons — Attribution — Noncommercial
Hello,
this is the fiveth part of the seven wonders, i used Ferdinand Knab's paintings as source model. You can resize the image in your slicer to 200*160 mm before slicing (i did it so, to make all print at the same size); and you can use any other black filament type, about the others i am not sure, but feel free to experiment. There is two .stl file, one with the stamp-like effect, and one without.
Printing:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 199.01x159.14mm in size
You may print at higher layer heights below the Base Thickness of 0.48mm
The Max allowed Thickness is 2.24mm and the Actual Thickness is 2.24mm
#080a0d PLA PolyLite Black Transmission Distance: 0.3
#4c5f71 PLA BambuLab Basic Blue Gray Transmission Distance: 3
#0a5780 PLA BambuLab Basic Cyian Transmission Distance: 3.5
#ffffff PLA Alzament White Transmission Distance: 5
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #13 (1.12mm) swap to Blue Gray
At layer #18 (1.52mm) swap to Basic Cyian
At layer #21 (1.76mm) swap to White for the rest.
Hope you like it, leave a comment, and have a nice day!