1 / 1
2-Liter / Soda Bottle Cap to 1/4" Drip Irrigation Adapter — zdjęcie 1

2-Liter / Soda Bottle Cap to 1/4" Drip Irrigation Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This cap is designed to allow you to fill a 2-liter bottle with water, and then attach a hose that will slowly drip…

Ocena
5 / 5
Polubienia
73
Pobrania
881
Wydruki
3
Wyświetlenia
3236
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This cap is designed to allow you to fill a 2-liter bottle with water, and then attach a hose that will slowly drip the water into a plant container over a period of time.

IMPORTANT: Cut a small washer out of craft foam to help seal the bottle to this cap. Alternatively, you could use a small rope of modeling clay or polymer clay to seal things up.

You can not use a typical drip irrigation nozzle with this as it does not have enough pressure to overcome the nozzle's diaphragm. Either modify a drip nozzle, or drill small holes in the 1/4" drip tubing. I designed this to slowly water tomato plants that are inside of a grow chamber at a slow rate to prevent spillage.

Modify it here: https://www.tinkercad.com/things/bajGxFj09p7

Print Settings

Printer Brand:

Prusa

Printer:

i3 MK2S

Rafts:

No

Supports:

Yes

Resolution:

0.15mm

Infill:

100%

Filament: Prusament Pla Grey


Notes:

Print at 100% infill, 8-shells, 7 surfaces for best water tightness. Paint with 5-minute epoxy if a leak occurs.

Category: Outdoor & Garden

Tagi