Camera Mount for MendelMax
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had issues with my mini tripod and LifeCam Studio when recording or streaming prints. So I designed a mount that…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
I had issues with my mini tripod and LifeCam Studio when recording or streaming prints. So I designed a mount that held the camera at the popper height, and synced the printer's vibrations with the camera. The result was a much more steady video of the print and I did not have to worry about the webcam and tripod "walking" from the viberations
I use a binder clip to hold my LifeCam Studio onto the mount but I left enough room that a 1/4" hole could be drilled for a 1/4"-20 bolt that will allow almost any camera with a tripod mounting hole to be affixed.
I have also included the .skp file if anyone wants to modify this.
Instructions
Fits any Lulzbot AO-100 and AO-101 as well MendelMax derivatives that use 20mm extrusions with a base that has an gap of 30mm between the bottom rails.
- Print out model**
- Clip onto base
*You will need to print out some feet to raise up your printer as the clip slightly raises the front of the printer.
** You will need a minimum bed of 200mm x 200mm x 30mm to print this object.
Category: 3D Printer Accessories