Pixhawk GPS mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Why print this?
I was previously using AliExpress folding GPS metal mount but I found out that it was oscillating. I also noticed that the double sided tape went loose after a few flights. My design is rigid enough to prevent oscillation or even tip overs on the mount. It has a slot for attaching the GPS puck with a medium sized zip tie. I used both double sided tape and zip tie. It is not foldable but gives a shorter option if height is an issue.
Recommended print settings:
Use raft, sufficient cooling to prevent dripping on the top cone, slow down (or minimum time per layer setting) and Z-hop at the top 30mm. No supports required.
Recommended print:
My favorite variant that you can also see in the pictures on ZD550 V1.2 frame is D40-L100 (D refers to the diameter that the GPS puck mounts on, L is the total Height of the mount).