1 / 7
Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives — zdjęcie 1
1 / 7

Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives

Ocena
0 / 5
Polubienia
25
Pobrania
170
Wydruki
0
Wyświetlenia
540
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial

Changes

  • I made it able to support a 10mm thick drive (instead of 7mm).

  • I also added fillets and chamfers just to kind of polish it a bit.

On my way toward doing a make of this nice design by Scott Gibb, I also created this remix. I used the Fusion 360 file that Scott provided (thanks for that).

Print settings

  • Filament: PLA should be fine. If you have concern about heat, use PETG. 

  • No supports needed if you are using a recent slicer that can concentric print the screw hole insets! I use OrcaSlicer, and it sliced the unsupported screw holes to print fantastically. Note: if your slicer is old, then yes, you should do supports on the case bottom that has the screw hole overhangs.

  • Perimeter walls: I did three (3). Two (2) would probably be OK, but adding the extra wall adds strength and only added about 2 minutes to print time!

  • Infill: I did the default 15%

  • Raft / Brim: no 

NOTE: the following is merely copied and pasted from Scott Gibb's listing:


3D printed 2.5" HDD Enclosure

A simple 3D printed case for an old 2.5" HDD. The case is designed such that, for the most part, it is a push-fit, with four nuts at the bottom, mounting the drive to the plastic case.

Equipment List

Links

The adapter and a variation of the hard drive used can be seen below:

Resolution:

0.4mm

Infill: 

5%

Filament:

Generic PLA

Notes:

Print with minimal supports

 

Technical Drawing

Exploded View