1 / 7
Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives — image 1
1 / 7

Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Enclosure for SATA 2.5 inch Hard Drive - for 10mm thick drives

Rating
0 / 5
Likes
25
Downloads
170
Makes
0
Views
540
Reviews
0

Updated at source:

Model information

Category
Computers
License
Creative Commons — Attribution — Noncommercial

Changes

  • I made it able to support a 10mm thick drive (instead of 7mm).

  • I also added fillets and chamfers just to kind of polish it a bit.

On my way toward doing a make of this nice design by Scott Gibb, I also created this remix. I used the Fusion 360 file that Scott provided (thanks for that).

Print settings

  • Filament: PLA should be fine. If you have concern about heat, use PETG. 

  • No supports needed if you are using a recent slicer that can concentric print the screw hole insets! I use OrcaSlicer, and it sliced the unsupported screw holes to print fantastically. Note: if your slicer is old, then yes, you should do supports on the case bottom that has the screw hole overhangs.

  • Perimeter walls: I did three (3). Two (2) would probably be OK, but adding the extra wall adds strength and only added about 2 minutes to print time!

  • Infill: I did the default 15%

  • Raft / Brim: no 

NOTE: the following is merely copied and pasted from Scott Gibb's listing:


3D printed 2.5" HDD Enclosure

A simple 3D printed case for an old 2.5" HDD. The case is designed such that, for the most part, it is a push-fit, with four nuts at the bottom, mounting the drive to the plastic case.

Equipment List

Links

The adapter and a variation of the hard drive used can be seen below:

Resolution:

0.4mm

Infill: 

5%

Filament:

Generic PLA

Notes:

Print with minimal supports

 

Technical Drawing

Exploded View