1 / 4
Halterung für Steuerung eines Radiallüfters/ Mounting bracket for controlling a radial fan — zdjęcie 1
1 / 4

Halterung für Steuerung eines Radiallüfters/ Mounting bracket for controlling a radial fan

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Lüfter für das Gehäuse des “PrintClosure Project”/ Fan for the housing of the “PrintClosure Project”

Ocena
0 / 5
Polubienia
0
Pobrania
6
Wydruki
0
Wyświetlenia
31
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Im Rahmen des „PrintClosure-Projekts“ habe ich diesen regelbaren Radiallüfter in das Gehäuse eingebaut. Zur Montage der Steuerung dient dieses Modell. Es kann direkt mit den im Gehäuse vorhandenen Bohrungen befestigt werden.

Das Netzkabel wird zwischen der Acrylglasscheibe und der Halterung geführt, sodass es nach unten herauskommt. Das Steuerungskabel wird nach unten und gleich wieder nach oben geführt, sodass es nach oben herauskommt. Überschüssiges Kabel wird im hinteren Fach verstaut. Durch das kleine Fenster ist die Betriebsleuchte sichtbar.

Beim Druck habe ich Support verwendet (siehe Screenshot).

Translation: DeepL

As part of the “PrintClosure Project” I installed this adjustable radial fan in the housing. This model is used to mount the control system. It can be attached directly to the holes in the housing.

The power cable is routed between the acrylic glass panel and the bracket so that it exits at the bottom. The control cable is routed downwards and then immediately back up again so that it exits at the top. Excess cable is stored in the rear compartment. The operating light is visible through the small window.

I used support for printing (see screenshot).

Tagi