Headphone yoke reinforcement / band-aid clip for TAH8506
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Clip that wraps around weak spot, making headphones usable again, even if it's already broken. Compatible with TAH8506
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Music
- Licencja
- Creative Commons — Attribution
This clip is quite crude but effective way to keep the headphones's headband functioning properly. It helps with failure of separation of top and bottom part of headband where it connects to headphone cup. It seems the weakspot of many headphones, and these aren't exception.
Ive made it to be fairly thick (2.4 - 2.2mm depending on spot) so it can survive daily use.
Print PETG, this should be one thick layer of plastic w/o any gaps inside for sturdyness. One edge is steeper, print on the less steep edge, no supports. Personally I printed on mk4 without brims 25mm speed profile without issue.
To mount it, pull the headphone cup into carrying/storage position, than just slide it over the yoke / headband, start with shallower edge, than just push it in. It should be fairly tight squeeze so it can hold it firmly.
If part is too tight (it should be tight!) you can edit solvespace project, on very first layer increase dimmensions (there are only one of each number):
25.35 to 25.45
25.85 to 26.00
3.45 to 3.60
12.80 to 13.00
2.00 to 2.05