1 / 5
Headphone yoke reinforcement / band-aid clip for TAH8506 — image 1
1 / 5

Headphone yoke reinforcement / band-aid clip for TAH8506

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

Clip that wraps around weak spot, making headphones usable again, even if it's already broken. Compatible with TAH8506

Rating
0 / 5
Likes
2
Downloads
14
Makes
0
Views
86
Reviews
0

Updated at source:

Model information

Category
Music
License
Creative Commons — Attribution

This clip is quite crude but effective way to keep the headphones's headband functioning properly. It helps with failure of separation of top and bottom part of headband where it connects to headphone cup. It seems the weakspot of many headphones, and these aren't exception.

Ive made it to be fairly thick (2.4 - 2.2mm depending on spot) so it can survive daily use.

Print PETG, this should be one thick layer of plastic w/o any gaps inside for sturdyness. One edge is steeper, print on the less steep edge, no supports. Personally I printed on mk4 without brims 25mm speed profile without issue. 

To mount it, pull the headphone cup into carrying/storage position, than just slide it over the yoke / headband, start with shallower edge, than just push it in. It should be fairly tight squeeze so it can hold it firmly.

If part is too tight (it should be tight!) you can edit solvespace project, on very first layer increase dimmensions (there are only one of each number):
25.35 to 25.45
25.85 to 26.00
3.45 to 3.60
12.80 to 13.00
2.00 to 2.05

Tags