Mokerlink 2G040210GSM 10" Rack Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A 10" 1U rack mount for the Mokerlink 2G040210GSM Switch
- Ocena
- 5 / 5
- Polubienia
- 1
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 148
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
This is a 1U, 10" Rack mount for the Mokerlink 2G040210GSM Managed Network Switch.
You can find the Onshape document (along with all of my 10" rackmount designs) here.
I have also included STEP files.
To securely mount the switch, it uses the two rear chassis screw points (M3 threads). There is not a lot of clearance inside the chassis (as you will note by the tiny length of the original screws) so I have padded the mount to allow use of longer more common screws up to 8mm long. I did not have any short countersunk M3 screws so I have designed it as a simple hole to allow using simple socket head M3x8 screws.
Of course, adapt to your needs using the onshape document or STEP files.
Test prints in PLA, PETG and PC-FR. With ELEGOO Rapid PETG each arm can easily sustain several kilograms of load without layer failure, so most materials will be adequate. On principle I would of course not recommend PLA due heat deflection, but the contact area for this switch is small so it might be fine long term.