Baby AT Mother Board Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Useful for a Retro Computer Mother board and working with it and trouble-shooting Video or Sounds cards on the bench.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 139
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
If you want to test a video card or sounds card or some other card on your test bench mother board, it is great to mount it and give it support. This gets the motherboard off the bench so cards can fit in to it without their bracket hitting the bench.
The holes are setup for 3mm heat press insert and then use 3mm screws to mount the motherboard to the frame.
Prints in about and hour and 18 minutes on Bambu Labs H2S using .4mm nozzle and .24mm standard print settings.
Rev 3: Sligh improvement on hole centering and added non-screw MB supports near the edges of the PCB.
Rev 4: Doctored it's looks up, less pure square. Has PCB supports at the far end of the board. May take slightly longer to print.
Rev. 5: Added four holes to screw it to a hunk of plyboard.