OpenGrid Lite Corner Connectors
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Connects into opengrid lite connector slots allowing opengrid lite panels to be connected in perpendicular planes.
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 77
- Wydruki
- 0
- Wyświetlenia
- 382
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
Update (2/15/2026): The openSCAD customizer by johnnydev13 on Makerworld is more versatile than my implementation.
I wanted to wrap some opengrid lite panels around my desk edge. Couldn't find a solution that worked and this is what I came up with. Opengrid connectors at 90 degree angles that allow opengrid lite panels to be connected at 90 degrees from each other. Adds a small gap on each connector of about 0.5mm.
Printing:
Print witht he chamfered edge facing down and the connectors pointing up at 45°. Prints quickly with no supports or brim.
Recommend at least 3 walls, otherwise the connectors don't print as cleanly.
0.2mm height and 15% infill both worked fine. I haven't different layer heights or infills
Asembly:
The longer the pieces are harder to snap in. I recommend using several smaller lengths when assembly is dificult. Use a length of at least 2. A length of 1 allows the frame to twist. Included this size to aid in remixing.
Where two opengrid lite panels meet, the connector doesn't quite fit, and serves no function. These can be cut cut with flush snips as needed.
Remixing:
Only including a single length piece. The longer pieces are just a pattern of that section at a 28 mm interval (opengrid spacing)