1/8 NPT & 3/8 NPT Protective Caps (Male & Female)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This set includes both Male and Female protective caps for the two most common small pipe sizes (1/8 NPT and 3/8 NPT)
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 28
- Wydruki
- 1
- Wyświetlenia
- 110
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This set includes both Male and Female protective caps for the two most common small pipe sizes in automotive and industrial plumbing: 1/8 NPT and 3/8 NPT.
These are perfect for sealing off ports on turbochargers, oil sandwich plates, fuel rails, or intake manifolds while your engine is being built or stored.
📐 Understanding NPT (Why they don't screw in all the way)
If you are used to standard bolts (Metric or AN), you might be surprised when these caps stop after only a few turns. This is normal.
Unlike "straight" threads, NPT (National Pipe Taper) threads are cut on a 1.789° taper.
The Wedge Effect: As you screw the male end into the female end, the diameter of the male part increases while the female part decreases.
Engagement: In real steel fittings, you typically get about 3 to 4.5 threads of hand-tight engagement before the threads "wedge" together to create a seal.
The Caps: These 3D-printed caps mimic this taper. Do not force them. They are designed to sit snugly after a few turns to keep dust out.
🛠 Print Settings
Material: PETG is recommended for better chemical resistance to oil/fuel residues and better thread flexibility.
Layer Height: 0.15mm (High detail is essential for the tapered NPT threads to function correctly).
Infill: 20% is plenty for a dust cap.
Walls: 3 wall lines.
Supports: None needed.
⚠ Disclaimer
These are DUST CAPS ONLY. Because NPT relies on metal-to-metal deformation and sealant (Teflon tape) for a high-pressure seal, these plastic prints should NEVER be used in a pressurized system or on a running engine.