Dual Mode Windup Car - REMIX
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Since Greg is no longer on Thingiverse, here is a link to his original design:…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 642
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
Since Greg is no longer on Thingiverse, here is a link to his original design:
https://www.myminifactory.com/object/3d-print-dual-mode-windup-car-27061
The main underbody mechanics has not changed at all. The only modification was made to add 608 bearings to the each wheel. (Some small reduction on the hex shaft as it was very hard to install into the spring and pawl...okay, two mods)
Where we did spend time was on the body... same lines but with added features, like, wider body, front and rear spoilers, front and rear lights, exhaust, windows, and rear side air scoops.
Hope you enjoy printing and building this car!!! Dave and I had fun designing it!!
Print Settings
Printer:
AM8 + Titan Aero
Rafts:
Yes
Supports:
Yes
Resolution:
0.2 mm
Infill:
20
Filament:
Various PLA
Various
Notes:
The only tricky part to assemble is the window... start with the bottom front and then the top. And then the rest.
Category: Models