Garmin D2 Air Watch Charging Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Garmin D2 Watch Stand for 90° charging connector.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 53
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Watch stand for Garmin D2 Air Watch. You can lead charging cable through the groove in the base plate. For easier printing, the stand is made of 3 parts. You will need 2x M3 hexagonal nuts and 2x M3x10 inbus screw.
Should anyone want to use square nut instead, let me know and I will provide this model as well. I simply changed to hex nuts as I run out of the square ones :-)
There are no specific printing instructions. Just print with 0,2 mm layer PLA, 2 perimeters and your favourite infill.
Assembly instructions:
- Print all 3 parts
- Insert 2 hex nuts into the holder arm. Push them firmly to the end.
- Use 2 screws to attach head on the arm
- Insert charging cable
- Push the plug over the center to hide screw heads
Disassembly:
To remove the charging cable, push small flat screwdriver between the plug and cable, twist a little and it will usually jump out ;-)
Arm shape was inspired by Watch Stand by @Fredslund. Check it out: https://www.printables.com/model/27759-watch-stand-no-support