opengrid - NonRotating Multiconnect Snaps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NonRotating Multiconnect standard and directional snaps for openGrid.
- Ocena
- 0 / 5
- Polubienia
- 21
- Pobrania
- 108
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
These are an alternate version of my openGrid Multiconnect Snaps, using a non-rotating multiconnect instead of the standard round connector.
The openGrid models included Multiconnect snaps with a threaded snap and a screw-in multiconnect connector. While the 2 part assembly allows using a folded screw that can be printed in a stronger orientation*, that isn't always necessary, so I made these simple snaps have the multiconnect connector as part of the snap. There are 2 different snaps, one using the standard snap (pushes straight into the openGrid tile) and one using the directional snap (an arrow on the back indicates the side that goes in first). These were made from the modeling files that David D provided with the openGrid and Multiconnect frameworks. The directional snap is based on the v2.1 directional snap.
My test prints were done in PLA with 3 walls and 15% gyroid infill.
*Please note that layer adhesion where the connector meets the snap body may be a limiting factor because of the print orientation. Although the snaps pulled out of the tile rather than breaking during my testing, it is possible that print settings or different materials will impact layer adhesion, so if you are planning to use this for something heavy, I would suggest making a test print first, or using one of the threaded snaps with a folding multiconnect connector.
Also available: