Hidden Myggbett
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Ikea Myggbett door/window sensor mod to use as built in.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 237
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model allows you to mount an Ikea Myggbett sensor in a 6cm deep 16mm hole.
It uses an N/LR1 battery, and the strip for the negative terminal must be shortened and bent to fit.
Requires a 6x9mm (or 3 6x3mm) round neodymium magnet. The original Ikea magnet is too week.
Only the circuit board and battery terminals are needed.
The original sensor is pretty hard to pry apart, and will probably be fully destroyed in the process.
The N/LR1 was chosen as it is shorter than the AAA that Myggbett normally uses, but has about 80% capacity still.
I have included a AAA holder as well, but it is untested.
I recommend printing in PETG as the flex of the material will help with the snap fit.