1 / 7
G&G SMC-9 Main Bolt Assembly (Part: GHJ-A04, A013, A015) — zdjęcie 1
1 / 7

G&G SMC-9 Main Bolt Assembly (Part: GHJ-A04, A013, A015)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The main body of the SMC-9 bolt.

Ocena
0 / 5
Polubienia
1
Pobrania
14
Wydruki
0
Wyświetlenia
78
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Sports
Licencja
Creative Commons — Attribution — Share Alike

This is a close 1:1 model of the G&G SMC-9 Bolt labelled (Part: GHJ-A04, A013, A015).

(Images showing only the rear being printed, but either side of the bolt will work with the OEM)

You will need the other parts that make up the whole assembly, including the ball bearing, spring and seals. Transfer all components and keep the stock recoil spring. 

This was tested using 80psi HPA, with all stock internals.

It ran well with slight deviations in the FPS, however, make sure the pin on the loading nozzle is secure, and any screws have loctite.

FEATURES

Higher ROF

Lower recoil 

Fast Semi responce

SETTINGS

Layer height: 0.12/0.2 with a 0.4mm nozzle

Infill: 15-20%

Walls: 4 

Inner wall flow: 0.5 (or 0.2 to current settings

Support: yes

The rest of printers settings such as support interface and speed and overhangs should be calibrated or would work with standard slicer settings.

I would recommend printing the shortened front bolt as I'm still working on reinforcing the bolt hold open arm so it does not snap in use. I will update soon.

If you have any questions, please leave a comment and I will get back to you.

Tagi