270 Degree Print-In-Place Hinges for Elegoo Centauri Carbon
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Print-in-place 270° door hinges for Elegoo Centauri Carbon. Remix of Mordiev's K1C hinge design.
- Ocena
- 4,333 / 5
- Polubienia
- 24
- Pobrania
- 164
- Wydruki
- 3
- Wyświetlenia
- 708
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
270° Print-in-Place Door Hinges for Elegoo Centauri Carbon
Upgrade your Elegoo Centauri Carbon with these functional print-in-place door hinges that extend opening range from the stock 90° to a full 270°, providing dramatically improved access to your printer's build chamber.
This design is a remix of Mordiev's 270° hinges for the Creality K1C, adapted to fit the Elegoo Centauri Carbon.
Designed for convenience, these hinges feature a print-in-place design that requires no assembly — the hinge mechanism is fully functional straight off the build plate, saving you time and effort.
Key Features:
Extended range: Opens to 270° (vs. stock 90°)
Print-in-place design: Functional immediately after printing
No hinge assembly required: The hinge mechanism works right off the print bed
Easy printing: Works with standard print profiles, no supports necessary
Material flexible: Compatible with PLA, PETG, ABS, or any standard filament
Printing Instructions
Print Settings:
Use your standard print profile
No supports required
Material: Any standard filament (PLA, PETG, ABS, etc.)
Layer height, infill, and speed: Standard settings work fine
Note: The display model was printed in PLA, but material choice won't affect functionality.
Post-Print Setup
Opening the Hinges:
Locate the hinge pivot point on the printed part
Grip near the hinge area (this is important for leverage and to avoid breaking the part)
Apply gentle pressure to begin separating the hinge
Gradually increase pressure until the hinge opens fully
Work the hinge back and forth a few times to break it in
Optional Cleanup:
Some excess material may be present on the gear teeth from the printing process
Use flush cutters or a hobby knife to carefully clip away any material that interferes with smooth operation
Test the hinge movement and trim as needed for optimal function
Installation
Required Hardware:
8x M3x6 screws
Steps:
Remove the stock hinges from your Elegoo Centauri Carbon door
Install the new 270° hinges in their place using the M3x6 screws
Test the door movement through its full range of motion
Enjoy your new hinges! You're set up and ready to go!