Jacobs Taper Wedges Gridfinity Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Gridfinity holder for JT2 and JT3 wedges.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 21
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a holder for one each pair of JT2 and JT3 Jacobs taper wedges in one Gridfinity square. These wedges are used to remove a Jacobs taper chuck from its arbor. There are wedges for other sizes available as well, but these are the two sizes I have. These are designed to fit actual Jacobs manufactured wedges; your mileage may vary if you have off-brand wedges.
Like my other Gridfinity models, the base is altered to accept 6x3 magnets as a press fit, with the upper surface of the magnet holes modified to make the slicer bridge across correctly for a clean result.
The unit pictured was printed out of Overture PLA on my Bear upgraded Mk3S+, using a 0.6mm nozzle, at 0.3mm layer height.