Jacobs Taper Wedges Gridfinity Holder
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A Gridfinity holder for JT2 and JT3 wedges.
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 4
- Makes
- 0
- Views
- 21
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Organizers
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a holder for one each pair of JT2 and JT3 Jacobs taper wedges in one Gridfinity square. These wedges are used to remove a Jacobs taper chuck from its arbor. There are wedges for other sizes available as well, but these are the two sizes I have. These are designed to fit actual Jacobs manufactured wedges; your mileage may vary if you have off-brand wedges.
Like my other Gridfinity models, the base is altered to accept 6x3 magnets as a press fit, with the upper surface of the magnet holes modified to make the slicer bridge across correctly for a clean result.
The unit pictured was printed out of Overture PLA on my Bear upgraded Mk3S+, using a 0.6mm nozzle, at 0.3mm layer height.