10 Inch rack with side and top panels – Remastered Design
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design is inspired by the excellent work of @Mauker . I Created an enhanced version with additional features.
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 35
- Wydruki
- 1
- Wyświetlenia
- 298
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
To print de basic structural you will need:
2 x 10-inch-rack-Foot
2 x 10-inch-rack-foot cross
4 x 10-inch-rack-Pilar
2 x 10-inch-rack-Pilar-middle
2 x 10-inch-rack-Top
2 x 10-inch-rack-Top-cross
1 x 10-inch-rack-Top cross -middle
The side panels uses magnets (9.5 mm diameter - 1.5/2 mm width) to be in place.
Top panels uses pressure fit.
The holes of the rack units from top and bottom are short and will screw into plastic (M5 - 10/12 mm lenght)
You will need to asemble the basic structure:
36 x M5 10mm bronce inserts.
12 x M5 20mm screws
6 x M5 25mm screws
6 x M5 30mm screws
For each module M5 25MM screws and nuts.
The magnets I used for the side panels were 9.5 mm and 1.5 mm width. You can use something similar up to 10 mm and 2 mm width.